Welcome to Op-Amps and Circuits. The quiz will randomly run 20 questions from Op-Amps and Circuits which you have to answer in 10 minutes.

After 10 minutes, your quiz will automatically be submitted and scored.

You can retake the quiz as many times as you want and a different set of questions will be given. The answers will also be randomly arrange.

Please click START QUIZ to start

A certain inverting amplifier has a closed-loop gain of 25. The op-amp has an open-loop gain of 100,000. if another op-amp with an open loop gain of 200,000 is substituted in the configuration, the closed-loop gain

Typically, an instrumentation amplifier has an external resistor used for

In an integrator, the feedback element is a

For an op-amp with negative feedback, the output is

In the differential mode of an op-amp,

The bandwidth of an ac amplifier having a lower critical frequency of 1 kHz and an upper critical frequency of 10 kHz is

If a certain op-amp has a midrange open-loop gain of 200,000 and a unity gain frequency of 5 MHz, the gain-bandwidth product is

In an op-amp, the purpose of offset nulling is to

Phase shift through an op-amp is caused by

In a differentiator, the feedback element is

A certain op-amp has a bias current of 50μA and 49.3μA. The input offset current is

Which of the following characteristics does not necessarily apply to an op-amp?

The frequency at which the open-loop gain is equal to 1 is called

With zero volts on both inputs, an op-amp ideally should have an output equal to

The output of a particular op-amp increases 8 V in 12 μs. The slew rate is

A certain inverting amplifier has an Ri of 0.1 kΩ and an Rf of 100 kΩ. The closed loop gain is

Noise on the input of a comparator can cause the output to

Of the valued listed, the most realistic value for open-loop gain of an op-amp is

When negative feedback is used, the gain-bandwidth product of an op-amp

Thank you for trying out Op-Amps and Circuits. If you comments on the quiz or on our site, please provide your comment

## Leave a Reply

You must be logged in to post a comment.